TAC 50

0 members (), 24 guests, and 2 robots.

Key: Admin, Global Mod, Mod

Forum Statistics

Forums13

Topics7,385

Posts40,939

Members10,040

Most Online3,137
Apr 9th, 2026

Print Thread

TAC 50 #14928 08/28/15 12:22 PM
Joined: Mar 2012 Posts: 57 KY, USA W WPeak wpeakjr
WPeak wpeakjr W Joined: Mar 2012 Posts: 57 KY, USA	We have been fighting the same issue for a while on this car. We have been thru several items as far as the following: Sent all boards (DSP, PMI; etc.) for testing and repair. Changed 5v power supply and set to 5.1 Checked for AC leakage into my DC power supply Changed the molex connectors on the DSP card Changed the governor encoder board. I get faults 109, 52, and 812. 109 = Encoder Cross Check Error 52 = Tach Fault Warning 812 Positive Torque Limit It is highly intermittent and will run at times for a week or more. Any help is appreciated.

Re: TAC 50 WPeak #14937 08/28/15 08:37 PM
Joined: Mar 2015 Posts: 69 On a Boat! Magic smoke Shaking the Bush!!
Magic smoke Shaking the Bush!! Joined: Mar 2015 Posts: 69 On a Boat!	Have you checked the governor encoder vs the motor encoder. They should be within 5 fpm of each other. When every circuit board is made. They put a little magic smoke inside.

Re: TAC 50 Magic smoke #14939 08/29/15 02:31 AM
Joined: Jan 2014 Posts: 736 R Rolly old hand
Rolly old hand R Joined: Jan 2014 Posts: 736	Sounds like a shielding problem. Check that shield wires are only connected at one end and check all grounding. Any radio transmitters close by?

Link Copied to Clipboard

Photo Gallery

service tool laptop
by dunkdadrunk, February 4

rip orona
by epic_ecodisc, January 7

what controller is this?!
by Alex_ELMAN, December 4

HW PM
by Chris, January 13

Drive sheave
by jkh, October 10

The best helper.
by Adrian, August 8

Home Forums General Discussion Technical Questions TAC 50