Miprom 21 Access Problem

0 members (), 25 guests, and 1 robot.

Key: Admin, Global Mod, Mod

Forum Statistics

Forums13

Topics7,385

Posts40,944

Members10,040

Most Online3,137
Apr 9th, 2026

Print Thread

Miprom 21 Access Problem #15188 10/08/15 02:22 AM
Joined: Oct 2011 Posts: 13 R Redexit stranger
Redexit stranger R Joined: Oct 2011 Posts: 13	I have a building with Miprom 21 controllers and Digital Drives. When I move the elevator on inspection in the up direction via: key access, controller UAX, or ride on car-top, that it travels a couple of feet and then it stops then travels again and it stops and it continues until I get the car to its destination. It only does this in the up direction not in the down direction. Any input on this will be greatly appreciated. Last edited by Redexit; 10/08/15 02:24 AM.

Re: Miprom 21 Access Problem Redexit #15243 10/14/15 02:33 AM
Joined: Mar 2015 Posts: 80 W Whadafack journeyman
Whadafack journeyman W Joined: Mar 2015 Posts: 80	Any drive faults? Or motion faults? Last edited by Whadafack; 10/14/15 02:33 AM.

Re: Miprom 21 Access Problem Whadafack #15248 10/14/15 12:38 PM
Joined: Feb 2013 Posts: 800 ohio J john jay old hand
john jay old hand J Joined: Feb 2013 Posts: 800 ohio	Turn the Parameter- Min Overspeed Band- to Maximum. Also make sure the timers on the relays Sb and P2 are correct. one of them has to be longer than the other, like 1sec and the other at 3/4sec. I think P2 is longer, but it has been a while so it could be visa versa.

Link Copied to Clipboard

Photo Gallery

service tool laptop
by dunkdadrunk, February 4

rip orona
by epic_ecodisc, January 7

what controller is this?!
by Alex_ELMAN, December 4

HW PM
by Chris, January 13

Drive sheave
by jkh, October 10

The best helper.
by Adrian, August 8

Home Forums General Discussion Technical Questions Miprom 21 Access Problem