Home Forums General Discussion Technical Questions Schindler 330a code 106 phase loss contact

Hi guys. We had storms and lost power on a Schindler 2 stop hydro. It lowered to 1st floor with door open and has a 106 block code. It's says it has a phase monitor open. On the print it's says its rkph contact is open. I cannot find this contact any where. I have all the proper power supply to my x12 including the safety circuit but no skd1 light. Can any one help with this ??

Is the reverse phase lit up

I don't see a reverse phase device. The drive monitors that and the drive is ready to go

is the ape unit on ?

The APE unit was not on. It turns out to b a bad mother board. Thanks for your help guys. I'm new to your forum I'm excited to be able to help out and participate.

Blown 5 amp glass fuse on bottom of board.