Tac20

0 members (), 96 guests, and 2 robots.

Key: Admin, Global Mod, Mod

Forum Statistics

Forums13

Topics7,404

Posts41,025

Members10,053

Most Online3,137
Apr 9th, 2026

Print Thread

Tac20 #18048 09/19/16 10:19 PM
Joined: Oct 2013 Posts: 120 C chicago member
chicago member C Joined: Oct 2013 Posts: 120	Getting 1041 fault. TAC20 ???don't remember this one..

Re: Tac20 chicago #18049 09/19/16 10:28 PM
Joined: Mar 2011 Posts: 153 Ga. xxXBlazeXxx member
xxXBlazeXxx member Joined: Mar 2011 Posts: 153 Ga.	Door WatchDog closing failure � DCL input did not activate in expected time interval. S Verify D21 and/or D22 adjustments Last edited by xxXBlazeXxx; 09/19/16 10:29 PM.

Re: Tac20 xxXBlazeXxx #18054 09/20/16 01:04 AM
Joined: Dec 2010 Posts: 642 Likes: 5 Central Utah E elmcannic addict
elmcannic addict E Joined: Dec 2010 Posts: 642 Likes: 5 Central Utah	Chicago- Be sure to check the door motor brushes. Closing torque Close start settings Dragging gib Too slow a manual close setting Marginal DCL input Soft spot on the primary door belt right near full close New belts= excess drag on motor= 1041 Be sure you don't have a door ramp preventing full door closure Or--- If it uses that magnet on the header for DCL, that may be a culprit as well. Be sure to let us know what you found to remedy your trouble

Re: Tac20 elmcannic #18072 09/20/16 11:27 PM
Joined: Oct 2013 Posts: 120 C chicago member
chicago member C Joined: Oct 2013 Posts: 120	Elmcannic, nice tips. I will be back to job friday. Will check your ideas. Thanks

Link Copied to Clipboard

Photo Gallery

service tool laptop
by dunkdadrunk, February 4

rip orona
by epic_ecodisc, January 7

what controller is this?!
by Alex_ELMAN, December 4

HW PM
by Chris, January 13

Drive sheave
by jkh, October 10

The best helper.
by Adrian, August 8

Home Forums General Discussion Technical Questions Tac20