Home Forums General Discussion Technical Questions TAC 20 - Linear/ belt operator

0 members (), 25 guests, and 1 robot.

Key: Admin, Global Mod, Mod

September
S	M	T	W	T	F	S
		1	2	3	4	5
6	7	8	9	10	11	12
13	14	15	16	17	18	19
20	21	22	23	24	25	26
27	28	29	30

Newest Members

Josephs, Javy89, Ropeguy67245, kywewa, Ingvar
10,040 Registered Users

Forum Statistics

Forums13

Topics7,385

Posts40,944

Members10,040

Most Online3,137
Apr 9th, 2026

Print Thread

TAC 20 - Linear/ belt operator #19752 03/01/17 03:33 PM
Joined: May 2013 Posts: 44 H hirise Mechanic
hirise Mechanic H Joined: May 2013 Posts: 44	Hey guys curious - didn't get a chance to check. ? Is a operator reset required after manually moving these operators when on INS. Didn't look at the board but its probably a Smartech II.

Entire Thread
Subject	Posted By	Posted
TAC 20 - Linear/ belt operator	hirise	03/01/17 03:33 PM
Re: TAC 20 - Linear/ belt operator	Indirtwetrust	03/02/17 01:58 AM
Re: TAC 20 - Linear/ belt operator	hirise	03/02/17 03:49 PM

Link Copied to Clipboard

Photo Gallery

service tool laptop
by dunkdadrunk, February 4

rip orona
by epic_ecodisc, January 7

what controller is this?!
by Alex_ELMAN, December 4

HW PM
by Chris, January 13

PECCO PH5000 Overspeed Governor
by stankap, September 24

Drive sheave
by jkh, October 10

The best helper.
by Adrian, August 8

Responsive Width:

PHP: 8.3.33 Page Time: 0.041s Queries: 16 (0.024s) Memory: 3.0165 MB (Peak: 3.5936 MB) Data Comp: Off Server Time: 2026-09-21 08:49:12 UTC
Valid HTML 5 and Valid CSS