Home Forums General Discussion Technical Questions Autinor BG15 issues

Hi there, I'm here again asking for info on issues with an Autinor AH32 BG15G.

http://imgur.com/a/wLPC7

Does anyone know if by switching those dip switches show in the above picture (link)
If it wipes the software on the main chip?

It seems the two led numbers on the print programming board have turned off.

http://imgur.com/a/DT5k0

Some pictures of the landing displays, im unsure of what they mean

The board in the picture is used for signal conditioning of the landing system tape head O03. The software is burned into EPROM and is non-volatile.

Not sure I understand your problem? Are you not getting anything on the display? It could be the display board.

Basically the lift no longer responds to landing calls. I am unable to drive it under maintenance also.

I have ordered a new EEROM chip from France, downside is that I have to reprogram everything, which I have no ideas about