I have a fun one. I have a Dover Solid State with partial prints. I do not have chart 1, chart 2, or block diagrams. I have those all in a book but I do not know if they are fairly universal. Can I use the generics in my book for troubleshooting any controller?

Here is what I have so far. Slot 2 pin B is broken. There are conductors wrapped around the pin on the back.

The car runs fine on inspection. When I put it in auto it takes a one floor run up, sequences properly to a level stop but does not open the doors. Then it starts in the up direction (not LU), as soon as the LD switch hits the vane the car levels back down and stops. Then starts in the up direction again until the LD switch hits the vane. It continues this pattern until I pull power or put it on inspection.

It will latch calls above and below. It seems to see a standing call but does not open doors.

Anybody got any ideas for me?

Thanks for any help you can give.