Home Forums General Discussion Technical Questions Schindler MPH

Hey does anyone have prints for Schindler MPH? I'm having a problem with the elevator getting stuck on the bottom floor about once a week or so. Can't get it to do anything without a hard reset. And I'm up Crap creek without prints and service tool. Also is there any way to turn off the pump running on the bottom floor to heat up the oil? (I'm guessing you need the service tool) Its unnecessary on this set up, the machine room stays at a constant 80-85 degrees.

Thanks guys

Something to check. Make sure the car doesn't move when it is heating the oil. Had this same problem on an MPH, had to readjust the valve sizing.

Thanks I will verify that next time I am in the building

Hello, Do you still need prints?

Yes please. My email is

I haven't had any issues with that MPH for over a month now. Kind of frustrating.

Thanks

I sent you a Drop Box link for the prints.

I sent you a Drop Box link for the prints.

I could use a set of those MPH2 prints if possible plz
[email protected]
On one now. Gettting start work get run