Home Forums General Discussion Technical Questions Kone KCM ADON learn

I just replaced a bad ADON board and I'm getting a 207 fault. How do I do an ADON learn on this controller? Thanks in advance.

Menu 5
Sub menu 7
Value 1 (or 2 for older models i believe)
The cpu will scroll through numbers..
Cycle power once the cpu reaches 5 7 1 (or 5 7 2)
Honestly i would just do both just to be safe.
Hope that helps

When I try and put the 1 or 2 value in it shows nOrdF. Menu 5 and submenu 7 entered great but won't let me enter a value.

Ok got into the value. Had to put it on inspect but now it's scrolling through the menus. We'll see how this goes.

Turn power off
Slide switch on Adon to the left
Power on
5-25 to 1
Wat till it says run on insp then do so either direction until stop is displayed
Power off
Slide switch to right
Power on

5-7-1 Lon Download
5-25-1 Adon Setup

Thanks LA Tech. That worked great.