I just had to replace a cpu and adon board ( old one was adon1, new is adon3) damaged by power surge. I’ve done adon learn and car runs on inspection and on auto for 1 run. Then I get 140n’s and 240n’s and I never get a shaft communication LED. I also get the fault for no B30 until I jump 30 to B30. There are no rear doors or rear calls. I’m think one or more lcehas/fcb boards are fried and I’m not ever completing Lon node download properly? I’ve checked all parameters and nothing seems wrong. Parameter 1-24 is set to 0. Is there a communication parameter or something like that I’m missing or is my original theory that the hall network is shot?