Home Forums General Discussion Technical Questions Otis GEN 2 EFO - P Problem

Hello. I have a problem on GEN 2. Although changing EFO - P paramater as 2, the elevator travels 1st floor. Could you help me. Thanks.

Do you have a floor below 1st? Basement?

I think you need to change EFO-CK too.

We have basement. Floor names are -1,0,1,2,3. thanks

There is not EFO-CK parameter. Could be a diffrent name of it. Thanks.

Where do you want it to recall to

we want to recall to "0" floor. Also the controller is GCS 222.
Best regards.

M 1-3-1--6 on tool which is emergency, then go on 26 times to EFO-P landing 1-64 is front doors
landing 101-164 is rear doors
landings 201-264 is both doors

also Next is EFO-CK Change to match EPO-P



after changing Do a reset M 1-5-1

should be good

I didnt find the EFO CK
I will check again. Thank you. Best ragards.

It should be right after EFO-P.... do you have a blue tool that is unlocked?

Have you changed EFO-P to 1 then blue enter. Then clear ram m-1-5-1. Then tried it?

thank you very much. I will make your advice. the elevator is in another city and far away. it will go 2 weeks later. best ragards