Home Forums General Discussion Technical Questions 330a 75 safety RTS fault

Hey folks,

We are getting the above referenced fault and the car runs on inspection. also seeing coldoi ast.

No fault codes on site. Any help is appreciated. Thanks and stay safe.

PUT CONTROLLER ON INSPECTION. THEN RESET. THEN HIT THE RESET AGAIN MID BOOT UP. AND POST BACK IF IT DOES NOT RESET

75 Safety RTS.
Basically is saying safe circuit is open after landing doors closed. Doors maybe bouncing back open after its closed. Or your Gate switch maybe opening... But typically that will throw up a 94 FATL

Thanks, it ran after the hard reset, to intermediate and top and then went to B with a fatl ast fault. This is a 3 stop B, G, 2.

I have run it up to 2 on insp and flipper it to auto and its still getting a coldoi ready AST and wont move.

Check oil level/ float switch

float switch was her. Back in service, Thanks

Hi!
It's my first contact with schindler and my biggest problem is that I do not have any manual.
I read the same 75 but the cabin is on the upper side and I don't have any access to the inspection controller.
Any help pls?

No need to access the cartop. Your CRIPNA board in the controller, also has the inspection (hand) controls.

Yes but I don't have the manual and I don't know ho to switch it in inspection mode!
Maybe someone have it!