Home Forums General Discussion Technical Questions Futura T Loadweigher setup

Anyone know how to setup the loadweighers with the owner service tool? Is there a NLD or FLD command?

You get any luck on doing that?
I'm just trying to figure out how to just bypass the CANRTM

I believe the Load Weighing is Load cells and they plug into the Car Position Transducer (CPT Board) P17. If your showing an overload condition try unplugging P17.

Also look at CSW 7 (CS7) Bits 6-7-8-9 control load weighing depending on set or reset. You can change bits with HyperTerminal if you know how to use it. Pretty sure Baud is 19,200 and rest is 8 data N no parity 1 stop bit. You would have to enter password of course.