CLC+ADJ+1+ENTER (CLEAR FAULTS)
EDT+1+ENTER+EDT+0+ ENTER (CLEARED FAULTS)
SEL+PAR+PRE (ENTER SETUP MODE)
CLC+ADJ+2+ ENTER +EDT (#FLOORS)+ENT+SAV (ADJUST NUMBER FLOORS)
CLC+ADJ+ (52,53,54,55,56,57,58,59)+ENT+EDT (NUMBER FROM TABLE TO CALL SERVICE GROUP AND CAR)
PUT ELEVATOR LOWER ENDING AND PUSH BUTTON IN SELECTOR CARD FOR ERASE FAULTS
GO TRAVEL IN INSPECTION FROM LOWER END TO TOP END (CHECK LED IN SELECTOR BOARD IS ON CONTINUE ALONG TRAVEL)
WHEN ELEVATOR STOP IN TOP END PLS SLOWLY PUSH TO DOWN AROUND 5" AND CHECK IF LED IN SELECTOR BOARD START TO BLINKING
NOW SEL+ADJ+0+SAV FOR SAVE PARAMETERS
NOW PUT IN AUTOMATIC
