|
|
|
0 members (),
25
guests, and
1
robot. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
S |
M |
T |
W |
T |
F |
S |
|
|
|
1
|
2
|
3
|
4
|
5
|
|
6
|
7
|
8
|
9
|
10
|
11
|
12
|
|
13
|
14
|
15
|
16
|
17
|
18
|
19
|
|
20
|
21
|
22
|
23
|
24
|
25
|
26
|
|
27
|
28
|
29
|
30
|
|
|
|
|
|
Forums13
Topics7,385
Posts40,944
Members10,040
| |
Most Online3,137
Apr 9th, 2026
|
|
|
|
Joined: Jun 2017
Posts: 36
newbie
|
|
newbie
Joined: Jun 2017
Posts: 36 |
After performing a unintended movement test with full load in down direction on a two stop front door only the controller latched a 99 fault and I can not reset this fault. I follow the Schindler instructions exactly and it will still not reset this fault. The load has been removed and I replaced the car top board on top of car thinking the problem was at that board but still no reset. Won’t run on inspection mode as well. When I push the enable button on controller inspection I only get 2 of the 4 *’s on display. Any help would be appreciated
|
|
|
|
|
Joined: Sep 2014
Posts: 170 Likes: 2
member
|
|
member
Joined: Sep 2014
Posts: 170 Likes: 2 |
99 is the state, condition, of the system......not the fault. You're getting the first two snowflakes from left to right? The third is doors. Did you put the unit on access then reset the unintended movement error?
|
|
|
|
|
Joined: Jun 2017
Posts: 36
newbie
|
|
newbie
Joined: Jun 2017
Posts: 36 |
Yes tried it several times without success. Turns out the cartop board that I replaced was for a front and rear setup and my elevator is front only. Once I got the right board installed it took the reset command for unintended movement. Those cartop boards look identical other than one terminal labeled JCH-2 I believe.
Thanks for your reply
|
|
|
|
|
Joined: Apr 2014
Posts: 280
Engineer
|
|
Engineer
Joined: Apr 2014
Posts: 280 |
Dam, what a painful find! Glad you got there in the end
|
|
|
|
|
|
|
|
|
HW PM
by Chris, January 13
|
|
|
|
|
|
|
|
|
|
|
|
