I'm having an issue with an MCE HMC-1000 with a GAL MOD operator. Customer was complaining of doors cycling every now and again. Finally witnessed it yesterday, I saw the doors close but the door lock LED on the controller wasn't lit. I figured it was just a simple adjustment of my limit since it was reported at all floors. Upon investigstion I saw the door would stop dead just before DCL would break, leaving my door rollers picked. My DC relay drops out, as soon as the car gets a demand holding torque takes over and car runs fine. RD1 and RD2 check out. My limit adjustments on the door are fine. I did try to increase the door torque a little to see if that would change anything, but that's sort of pointless since DC relay drops out anyway. I did check all contacts on door op and cleaned. Didn't have a lot of time to go much further. Just wondering if anyone has any other suggestions. I was thinking I could speed up closing speed to get it to slide in, but I'd rather cure the issue than mask it. Thanks
