Correct, DOL seems good visually. Again I was there doing other work and picked up on this after customer mentioned it so didn't have much time. When I go back I'l be probing with the meter a bit more to see what's up. I did check the resistor in the door operator for any breaks, along with RD1 and RD2 in the controller. All seemed good. One more thing I remembered, if it sits at the fllor with no demand and the door is in the state which I've been describing. If I hit the reset button on controller or cycle power, upon power up it does close the door to fully closed. So it seems that it's looking for DCL. I hope that doesn't confuse anyone. Again, thanks for all the suggestions it's much appreciated.
