So I've got a dinosaur I'm trying to get going until new controllers come in. As far as the circuit goes the unit acts like it wants to run. It's in the overhead, I've got the final jumped out and I've got a down direction sealed in, I can even see the brake picking. When we took the job over the brushed hadn't been changed and the commutator was damaged. We had the generator repaired and hooked it back up but not sure what else needs to happed. On the print it looks like I'm having issues around area 15 when I get into GF5. Not sure if this unit is a 10-21 or 30 the prints I've got say they're good for all 3. Any help is much appreciated.
