Home Forums General Discussion Technical Questions Miconic A w/SSDC drive

I have a Miconic A with a reliance Maxpak SSDC drive that is overspeeding, even in inspection. The motor checks out, the encoder is new, the governor encoder is ok, the boards are ok, so I’m into the drive SCR’s (which appear ok) or wondering if there is an issue I can verify with my phase rectifier modules.

Has anyone seen anything like this? I will either fault the car out with a hand overspeeding fault or trip my DC breaker for the drive. Any help or pointers are appreciated, thanks in advance.

Make sure the encoder has the correct PPR.

I had the same problem. Ended up being the tiny set screw on the encoder coupling was loose.