Home Forums General Discussion Technical Questions Tac 50-04 Rescue

I have a 50-04 32 bit MRL that is showing rescue operation and cannot be cleared. The error log loops 1114 1907. Incoming power reads good as well as reverse phase. Figuring to start by changing IOC? My print doesn't show rescue circutry but the switch operates from IOC. Is that a direct swap?

Changing IOC had no effect. Car still acts as if its in manual rescue mode

What is J16 set to? Should be 19

I ended up finding that later on. Not sure why that would have changed but it cleared up after that. I thought IOC was no good when no inputs would update. Thanks for reply

It happens sometimes. Manifests differently depending on what it changed to.