Hello. I’m getting a 1030 then a 1009 (Init SD down)
Very intermittent. However I think I witnessed it once. It’s a 4 stop and it seems to happen at the top floor. The door opens. Then closes a few inches and the indicator goes blank and doors lose power. Then all of a sudden it comes back to life and doors close and it goes down.
1009 - valve contact error. (MCD open ) down run failure, valves or MC not ready. MCD inactive or MCE active during down run
. Defective MCD input
. Defective MCE input
. Defective relays
1030- Leveling sequence error - Leveling inputs activated in an invalid sequence.
Any ideas Would be appreciated.
Do I need lon cable to change input ports? Don’t have one
I have old IMS
