Home Forums General Discussion Technical Questions Kone parameter unlock LCE V6.7.18

Anyone know of a unlocker tool that will unlock a Kone lce with 6.7.18 version software?

I've tried a relatively cheap unlocker tool and Modutool, both unsuccessful.

Dont think it can be done, KONE always put this software version in, when they the loose a unit.
Just update the software to a higher version, then use the LCEUIO or Modutool to unlock the interface.

/Alex

Can you help me through the process of updating the software?

Or can the KNX board unlock parameters?

pm on the way.....

Please kone unlock lce parametro cpu..thanks

if the drive still has the nvram, not the soldered memory, it will suffice to fill it with FF and put it back, but you will need to re-enter the install parameters. This process can be tedious if it is a device with special characteristics, if it is a standard device with a single entrance and without keys, all you have to do is read the hole to recognize the floors and address the remote stations (floor plates )