Home Forums General Discussion Technical Questions GAL Door operator troubleshooting

Janus photo eye, gal movfr2 door operator.

Don’t have any door operation in full auto and doors start closing only when photoeye is blocked… any idea as to what could cause this?

Try swapping input board for close. You might have one for heavy doors which isn’t being used.

Sounds like your edge is wired backwards. N/O vs N/C contacts.

Dirt is right.

You can always try putting it in phase 2 to cut out the light curtain to rule it out

That is exactly what came to mind and willing to bet money on that being the problem.

Easy fix! Was in N/O instead of N/C. Fixed it yesterday morning! Thanks for the help guys. Work safe

I always wire the contacts backwards! I do it nice bc I do it twice!