I've been remiss to update you, my esteemed colleagues!
Sh#t, I've been so busy, sorry..
If I am on the car (245#), it stops accurately at all three floors,
up and down.
But if I get off the car, it will stop just fine to all floors up+dn, EXCEPT
the top floor. Going to the top empty, it comes in very controlled,
stops, then as the main brake is setting, it rolls up a bit, trys to level down,
61u+61n high), sets the brake, rolls up, etc, etc, then after a number of tries
it faults out. I suspect it only does this at the top floor, because all the
host ropes are hanging down the cwt side.
We got both brakes pretty close, about 003", but Monday I'm gonna do them
again.
Is there a timer that holds anti-rollback torque until the brake has well
and fully set?
I was so busy Friday, I didn't check loadweighing, but will Monday
Thanks everybody
