Home Forums General Discussion Technical Questions Tac- 32 fault 2802 - NP Bottom terminal slowdown

0 members (), 16 guests, and 1 robot.

Key: Admin, Global Mod, Mod

September
S	M	T	W	T	F	S
		1	2	3	4	5
6	7	8	9	10	11	12
13	14	15	16	17	18	19
20	21	22	23	24	25	26
27	28	29	30

Newest Members

Josephs, Javy89, Ropeguy67245, kywewa, Ingvar
10,040 Registered Users

Forum Statistics

Forums13

Topics7,385

Posts40,945

Members10,040

Most Online3,137
Apr 9th, 2026

Print Thread

Re: Tac- 32 fault 2802 - NP Bottom terminal slowdown Rhubbard97 #35433 06/30/23 05:50 PM
Joined: Dec 2015 Posts: 1,767 Likes: 11 Local 18 I Indirtwetrust ElevatorPractitioner
Indirtwetrust ElevatorPractitioner I Joined: Dec 2015 Posts: 1,767 Likes: 11 Local 18	That’s Viscosity, heating up the oil. Probably not related to your 2802 fault. For that you should check your down NTS magnets on the back of the tape and P18 are set correctly for your rated down speed.
	1 member likes this: Rhubbard97

Entire Thread
Subject	Posted By	Posted
Tac- 32 fault 2802 - NP Bottom terminal slowdown	Rhubbard97	06/30/23 05:33 PM
Re: Tac- 32 fault 2802 - NP Bottom terminal slowdown	Indirtwetrust	06/30/23 05:50 PM

Link Copied to Clipboard

Photo Gallery

service tool laptop
by dunkdadrunk, February 4

rip orona
by epic_ecodisc, January 7

what controller is this?!
by Alex_ELMAN, December 4

HW PM
by Chris, January 13

PECCO PH5000 Overspeed Governor
by stankap, September 24

Drive sheave
by jkh, October 10

The best helper.
by Adrian, August 8

Responsive Width:

PHP: 8.3.33 Page Time: 0.046s Queries: 18 (0.031s) Memory: 3.0134 MB (Peak: 3.5900 MB) Data Comp: Off Server Time: 2026-09-21 21:02:09 UTC
Valid HTML 5 and Valid CSS