Hey Guys,
Me and our mechanics have been fighting with this intermittent problem on a Schindler 400A unit that we rarely see up here on the west coast of Canada, and can't quiet get her sorted. There is a list of faults that come in as followed:
Error Drive
148 Safety T4
18:14:23
Short Drive
99 RSK Fault
18:18:07
Error Drive
148 Safety T4
19:17:33
Perm Drive
67 KUET Fault
19:17:46
This same string is happening anywhere from once a week to once a day, and although we have the prints and controller manuals that are "close" to this unit, we don't have the exact GX manual which would be helpful, but we have asked for it before on VatorTrader and from Adams, and nobody seems to have any information on these damn things. The hoistway learn procedure never seems to take either, there is reference to a IMOF Montage switch on the ASILOG board which doesn't appear to be there, but again, this might be due to the lack of job specific manuals. We tried cleaning the Banner optosensors on the leveling system but didn't make a difference. tried swapping the relays, thinking it was a monitoring problem, double-checked the canbus wiring and all connections, and its all good. we are STUMPED. It is a duplex unit so the site hasn't kicked us to the curb yet, but we are getting to the end of our rope!
If anyone has the manuals for the Miconic GX, circa 2011, that would be extremely helpful. that or just some help if you are familiar with these beasts.
