So I was able to get back to this job, and it turns out it was overshooting the 2nd floor, and when it would hit TSL switches, this is the point where the pump would continue to run with no coils energized. Turns out I’m not slowing down when passing the 2nd floor at all. I checked my limit tree and tried making adjustments to my selector slowdowns. I attempted several hoist way learns with no effect on the issue. When I checked my CLC variables, all of my 27 (CLC outputs to SEL) variables would make sense. When I looked at my corresponding selector variables 3 (input flags from CLC), my inputs would be flashing on and off. I’ve got a selector from another job that I’m going to bring with me and start changing boards.
