Having an issue with a TAC22 displaying INIT SHTDWN. 188E Board was sent out for repair due to a bad CST IO. Board came back and CST IO works now, but car won't run. No faults. Car is about 3" above the floor. I have attached pictures of my IO map and my door operator. I think the INIT SHTDWN is being caused by the DOL/DCL/SE IO's. But my door operator appears to have no comms with IMS? It is the old GAL MODL door operator. Can I move IO's on this controller? I have tried injecting DCL and SE but nothing changes. Appreciate any help.
Just went back to this job. Still getting INIT SHTDN. Also getting a 1034 and 1090/1091 faults for LON but no LON on a TAC22. Expansion boards appear to be connected properly. Not sure what D12 should be set to on this. It is set to a 1 currently. Still having issues with DOL, DCL and SE also. No prints so difficult to diagnose. Appreciate any help.
