Push button

0 members (), 26 guests, and 2 robots.

Key: Admin, Global Mod, Mod

Forum Statistics

Forums13

Topics7,385

Posts40,939

Members10,040

Most Online3,137
Apr 9th, 2026

Print Thread

#3704 05/28/12 02:21 PM

Joined: Feb 2011

Posts: 29

F

newbie

Push button

Hello Anybody know where I could find this type of push button ?
Thanks

7 Comments

Re: Push button frankyboy #3716 05/29/12 02:12 AM
Joined: Sep 2009 Posts: 404 Orange County, California Administrator Administrator
Administrator Administrator Joined: Sep 2009 Posts: 404 Orange County, California	What type of elevator did you pull this from? It almost looks like something Innovation was putting out for a while. Is this for a Bar Button or standard button? Try sending this pic to the folks at Innovation. Good Luck!!!!!

Re: Push button Administrator #3718 05/29/12 12:35 PM
Joined: Feb 2011 Posts: 29 F frankyboy newbie
frankyboy newbie F Joined: Feb 2011 Posts: 29	Good morning It was install in a old Kone / Montgomery elevator but not sure this was the original button ? Thanks

Re: Push button frankyboy #3724 05/30/12 12:32 AM
Joined: Apr 2010 Posts: 60 F fateinc2005 journeyman
fateinc2005 journeyman F Joined: Apr 2010 Posts: 60	It's a 220 series button kone/ montgomery there junk foam wears out button no longer works you can take the foam off and glue two little washers in place of foam there available from Kone spares

Re: Push button fateinc2005 #3727 05/30/12 01:52 AM
Joined: Apr 2010 Posts: 60 F fateinc2005 journeyman
fateinc2005 journeyman F Joined: Apr 2010 Posts: 60	I tried to edit new ones are available from kone spares or Adams .Its such a waste to use the foam when the buttons really never go bad foam just wears out.

Re: Push button fateinc2005 #3732 05/30/12 09:14 PM
Joined: Feb 2011 Posts: 29 F frankyboy newbie
frankyboy newbie F Joined: Feb 2011 Posts: 29	You are exactly correct the push button still good just the foam wear out . I did the same thing I glue a pieces of plastic on top of the push button . But I still need to order some , I have some that not working after receiving rain . Thanks I will look again in Kone Spare .

Re: Push button frankyboy #3762 06/01/12 10:57 PM
Joined: Jul 2010 Posts: 49 california vince90605 newbie
vince90605 newbie Joined: Jul 2010 Posts: 49 california	i guess im cheap i usually fold up a piece of paper out of my pocket pad and install it in the button been good for about 3 years now.

Re: Push button vince90605 #4056 07/10/12 01:26 AM
Joined: Apr 2011 Posts: 565 orange county, CA Vic jack of all depts
Vic jack of all depts Joined: Apr 2011 Posts: 565 orange county, CA	Adams told me they wanted $750 for this button board! Kone spares wants $75, still expensive! Worth about a nickle.