Hi have a problem with a gen 2 after lightning strikes in the area. Original state was "DCS start". It wouldn't do a dcs run though due to DOL always high. That was because It had lost a bunch of parameters like DOL, DOB and top floor. After putting those parameters in the elevator performed the DCS run, stopping at all floors. However it only opened its doors at the bottom and top floor (5 floors) Now the elevator only takes calls to top and bottom and not the floors between in the car, and on the landing the second floor button calls it to the top, but the bottom floor button calls it down to the bottom floor just fine.
All the buttons are correctly addressed and to the correct floor. It's addressed to full collective.
All the parameters say "new" as well so perhaps it's been wiped and reset to defaults.
Is there a parameter I might be missing here to get the DCS run
to open the doors at all floors ??? As I think that's causing the buttons not to work properly. Any advice appreciated.
