Has anyone else had an issue with the DMC-I and FAST tool failing to adjust door speeds? The FAST tool uploads the speeds but it has no effect on the door operator. It shows the new speed was entered and saved but it will not increase the open or close speeds. When I power off the car, and back on, the door will open at the new speed that I loaded, but only once, upon the initial start up. After that one time, it opens and closed very slowly. I had another issue here with the door motor which hand me replace the motor bushes, they were nubs before I replaced them. That caused a fault (forget which one) but the new brushes resolved that issue. So I decided to adjust the open speeds and the operator will not respond, other than when it powered off and on for the first time.
Anyone know what I'm missing here? Any help would be greatly appreciated.
