Dover DMC1 hit by lightning. Replaced CLC board, selector boards, and both door operator boards (front and rear EDR2) boards. Only have access to the world tool. Hoistway scan works but reads a saved value of “0” after the learn. When attempting to learn the doors it will read “0” for “open limit to close limit” and also have no saved value of course. Replaced the world tool and still the same issue.
We were able to get it running temporarily with the doors opening virtually on inspection, just with the speed bumped up and adjustments redone. Going to schedule a day to call World but they’re notorious about not responding in a reasonable timeframe.
I know the floor table saves are finicky. I’ve tried doing it a hundred different ways. Starting below the BDL, running it down an inch before saving. Everything I can think of for it to save the table.
