Have a 188e replacement board back from repair where it was tested and worked fine in Simulator (2nd time). When I put it in my controller, no WD LED on 188e. They claim to have loaded generic sw in board so that when I got it back I could just load the job file. Can’t connect through IMS (guessing because no WD?) and when trying Hyperterminal I’m not able to set it up correctly on this laptop. See attached photos. Not sure what is going on with this but I’m not sure what is going on with this job. I’ve got 24vdc, 115vac & 3v battery is good on 188e board.
