Originally Posted by Aaron Grimes
I have a BC60 indoor use model that will not lower. The unit will raise but will not lower. Have to manually lower by turning the screw drive by hand. I can hear the stitches activate when pressing any of the three up switches and again, it works. But when pressing the switch for down (on any of the three switches), nothing happens. Has anyone had this issue before?

I am willing to replace the up/down switches just to see if all three have gone bad on just the down portion but need to know where to get the parts.


Is unit have pan switch's? When set, will run up but not allow to run in down.

“Every elevator has a personality. Some run for twenty years without complaining. Others know exactly when the state inspector pulled into the parking lot.”