Had a faid test. Originally nothing happened because 24f was dead once I got that sorted car recalled properly but would not reset. Print only shows 2 position switch but car has 3 position with bypass but bypass only makes FIR go hot so same as only having on off. So what is the sequence after turning to off that resets the fire recall? FE never goes low after initiating the egress landing smoke car goes up opens the door but will never drop even after the panel is reset. But phase 1 and phase 2 work as they should I know it’s not the key switch. Thinking something on the personality board or an actual issue with the I/O board and FE relay? Any advice is appreciated or if someone has a write up on the personality board jumper info that would be amazing. Thanks in advance!
