Home Forums General Discussion Technical Questions Any advice would be appreciated

Hey,
So currently I am working at this old factory with a Dover oildraulic elevator. I guess they were messing with it and the motor burned up and they installed it themselves. I currently have it at the bottom floor of 2 levels. However I can get a few contacts that pull in, (leveling switches had been moved above car). The last one I need for the motor to kick on "U" wont pull in. I believe I have a bad relay with a NC contact on "LO" however I am not at all familiar with the terminology on this page. Can provide more info, guess more of a push in the right direction is what I am looking for.

Thanks in advance.

Call vertical express snd get a full aet of prints. LO is low oil. Dover referred to their 3/4 slot card units as oildraulic. The prints will show test points on those cards.

Are you still needing information for this unit? Pm me if you still need a full manual