|
|
|
0 members (),
31
guests, and
1
robot. |
|
Key:
Admin,
Global Mod,
Mod
|
|
|
S |
M |
T |
W |
T |
F |
S |
|
|
|
1
|
2
|
3
|
4
|
5
|
|
6
|
7
|
8
|
9
|
10
|
11
|
12
|
|
13
|
14
|
15
|
16
|
17
|
18
|
19
|
|
20
|
21
|
22
|
23
|
24
|
25
|
26
|
|
27
|
28
|
29
|
30
|
|
|
|
|
|
Forums13
Topics7,385
Posts40,939
Members10,040
| |
Most Online3,137
Apr 9th, 2026
|
|
|
|
Joined: May 2018
Posts: 15
stranger
|
|
stranger
Joined: May 2018
Posts: 15 |
Thanks in advance. Otis 211 Phase 2, it is in fault fslr, the selector signals are good in the I/O board, i need to change some parameters but when i reset the controller the parameters go to preview number.
No Service Tool can talk with the elevator ( i dont know why) i have tested four diferent Service Tool in both elevators.
So, how to put in off the write protection from the controller, i suppose it is what avoid to change the parameters.
|
|
|
|
|
Joined: Jul 2018
Posts: 71 Likes: 2
journeyman
|
|
journeyman
Joined: Jul 2018
Posts: 71 Likes: 2 |
copy parameter chip onto a new chip. software version is too old, need AAJ or newer.
|
|
|
|
|
Joined: May 2018
Posts: 15
stranger
|
|
stranger
Joined: May 2018
Posts: 15 |
The version is AAI, Where can i find the newer version? it is suppose i should contact to OTIS, Correct?
|
|
|
|
|
Joined: May 2018
Posts: 15
stranger
|
|
stranger
Joined: May 2018
Posts: 15 |
Where connect the service tool in otis 211 phase 2? I see only Diagnostic connector and the ST doesn’t work there. Others models have Diagnostic and ST connector.
If I connect the ST in Diagnostic I get the same result in any model, so Diagnistic isn’t the correct one for the ST.
Does 211 phase 2 use ST?
|
|
|
|
|
|
|
|
|
HW PM
by Chris, January 13
|
|
|
|
|
|
|
|
|
|
|
|
