Evening,
Working on this car which took a hit were all assuming as it took out the drive and GCIO board. Had a buddy's CADI and seen that the parameters were all off, geared said gearless and on and on. So replaced the GCIO360 board (third one, Adam's kept sending the wrong one) and now power the car up... Mind you dont have the CADI now
On inspection, ebrake released, screen comes on with "Wrong Lift ID Check Settings" the pot is turned to 2 as it was previously and never touched. Do I need to go back in and change the Car ID via CADI or
Car will not respond to any command or demand, screen stays on the above.
