Update- i ordered new 222-Z8 relay coils for all the floor relays, and (2) of the 222-W19 2 wire coils for the CK and BL relays (car door close button, and emergency call cancel(?)) so while waiting for them to arrive, I removed the CK and BL coils, then just for the heck of it I powered up the elevator, and all of a sudden it is working almost perfectly! The door used to close on you regardless of whether you were in its way or not, the eyeball sensor would beep when you crossed it’s path and broke the beam, but the door would still close on you- now if you cross the threshold and break the beam, the door stops, slowly opens, then closes again and goes on its way. No more cycling the doors open and closed. Any ideas why disabling those two relays would fix the issues I was having? One thing I did observe is that the terminals of the BL relay have 120v across them at all times, which I find strange. I traced the wires back and it is the F51 and SG2, the F51 has 120vac to ground, the SG2 has 11.74vac to ground, and when the relay is energized, it just closes the circuit between the two. I’m not sure that’s how it should be or not.any ideas?
