Schindler 330A

0 members (), 16 guests, and 2 robots.

Key: Admin, Global Mod, Mod

Forum Statistics

Forums13

Topics7,385

Posts40,945

Members10,040

Most Online3,137
Apr 9th, 2026

Print Thread

Schindler 330A #3873 06/13/12 05:56 PM
Joined: Jun 2012 Posts: 48 L local yocal newbie
local yocal newbie L Joined: Jun 2012 Posts: 48	I have a stuck input on KHU. I replaced the board in the c.o.p and the main relay board in the controller. The only board left is the software board. Magnetic switches on cartop are ok and have been taken out of the equation. Any suggestions?

Re: Schindler 330A local yocal #3874 06/13/12 09:28 PM
Joined: May 2011 Posts: 487 E E-man addict
E-man addict E Joined: May 2011 Posts: 487	Try shorting the cap on the GCIO360PCB - power off, pull GCIO360, short that big round cap (2 pins on back of PCB) for about 1 minute. Last edited by E-man; 06/13/12 09:31 PM.

Re: Schindler 330A E-man #3878 06/14/12 01:11 AM
Joined: Oct 2010 Posts: 280 G GreenPants GreenPants
GreenPants GreenPants G Joined: Oct 2010 Posts: 280	best thing for a 330a and trx5 is the double reboot ram flush. on inspection push the reset button and as soon as the red light turns on again push and hold the reset for 5 sec. this clears the ram that is probably held charged by that cap.

Re: Schindler 330A GreenPants #4264 08/06/12 05:54 PM
Joined: Jun 2012 Posts: 48 L local yocal newbie
local yocal newbie L Joined: Jun 2012 Posts: 48	Software board fixed it

Link Copied to Clipboard

Photo Gallery

service tool laptop
by dunkdadrunk, February 4

rip orona
by epic_ecodisc, January 7

what controller is this?!
by Alex_ELMAN, December 4

HW PM
by Chris, January 13

Drive sheave
by jkh, October 10

The best helper.
by Adrian, August 8

Home Forums General Discussion Technical Questions Schindler 330A