Ok having an issue with a Miprom SL. Here's how it started, a few months back the car top got wet on a 4 stop, front only, simplex. The car top board and neuron was burned along with the wiring to it. After replacing the wiring, the board, and the encoder neuron we were able to run a floor scan and get it back working but it would shut down intermittently at different floors and would require a reset of the power. We since found out that the encoder neuron had different software than the other neurons and replaced all neurons with new version containing the same version software along with the board in the controller. Now, after a new floor scan, we can't go to floors 3 and floor from the car. All hall calls work and you can set up a car call to 3 and 4 from the tool but that's it. Now, we swapped the car station 2 neuron by putting in the original which contains an older version of software and it works but I'd like to know why the new neuron doesn't. Is there a setting I'm missing in the new neuron? Do I need to configure the car station through the tool? If I do, how? Any thoughts would be greatly appreciated as Line won't even return our calls to support the boards we just purchased from them. Thanks and be safe.
