The real reason I ask is because during re-opening when the detector is activated,it is very sluggish and sometimes times out before getting fully open.
They basically stall.
I assume it's nt timing out,but can't physically check it by myself.
Normal opening is fine.
I had an open dm1 resister,replaced and put all the bands back in the same place.
Did I mention it's a 7300 door operator?
Been through do,dol,dct,ro and nt relays.
These are all slimline relays,and I know all about the ins and outs of them,believe me.
My prints don't have a nt relay,but they do show a dr relay,which I don't have.
