Communicating with new Otis equipment

0 members (), 33 guests, and 2 robots.

Key: Admin, Global Mod, Mod

Forum Statistics

Forums13

Topics7,385

Posts40,939

Members10,040

Most Online3,137
Apr 9th, 2026

Print Thread

Communicating with new Otis equipment #5320 12/13/12 04:43 AM
Joined: Jan 2011 Posts: 37 SoCal C classic_chevy newbie
classic_chevy newbie C Joined: Jan 2011 Posts: 37 SoCal	Anyone know if there is a way to communicate to an Otis controller without using the service tool... Like using Hyperterminal or something similar? Looking to communicate with newer Otis equipment but it is my understanding that GCS controls require a NEW service tool. Anyone have any input on this?

Re: Communicating with new Otis equipment classic_chevy #5324 12/13/12 02:48 PM
Joined: Oct 2012 Posts: 262 P Philly enthusiast
Philly enthusiast P Joined: Oct 2012 Posts: 262	There is an aftermarket tool from China for $500. It works. www.aliexpress.com

Re: Communicating with new Otis equipment Philly #5332 12/14/12 02:25 AM
Joined: May 2012 Posts: 194 L Len member
Len member L Joined: May 2012 Posts: 194	I wish you a lot of luck with that one...the Global System is very much a locked system..very few have limited access to this service tool, unless you are an adjuster or engineer..very different from the past elevonics...

Link Copied to Clipboard

Photo Gallery

service tool laptop
by dunkdadrunk, February 4

rip orona
by epic_ecodisc, January 7

what controller is this?!
by Alex_ELMAN, December 4

HW PM
by Chris, January 13

Drive sheave
by jkh, October 10

The best helper.
by Adrian, August 8

Home Forums General Discussion Technical Questions Communicating with new Otis equipment