Been finding a car timed out of service last 3 days when I come in. I received the port I needed today to use my computer. Pulled up the faults 39 and 38 faults. Had 68 of them. I went to adjusted my MI+ and MI- voltages on the NTS board. I set the bottom with no problem. When I did the top I had no problem until I went to set the 6.4vDC with only 2 relays up. I had no voltage on my meter. Went to my Motion excuses it says reset drive. It took a couple times running the car on inspection up and down for the drive to stay up and let me set the voltage. Would this be a bad NTS board or would it be something feeding this board that is causing this. I am waiting on prints to get mailed to me all I have is a limited manual and service tool. Or since that voltage was off would it be causing the drive to do that.
