Looks like I have to clear the Memory first before I install the Lithium Batteries. I will try this tomorrow.
Step 1: Unplug and remove the original rechargeable battery
Step 2: Fix the new battery to the enclosure with double-sided tape and plug it in.
Replacement batteries can be ordered from Draka Elevator Products. The part number is
SEISMIC-BATTERY.
Lithium Battery Replacement
The onboard battery controller keeps track of lithium battery voltage and total battery runtime to provide a more accurate assessment of when the battery is nearing end-of-life. This
information must be cleared when new batteries are installed.
To clear the memory for a new battery:
Step 1: While Main Power (PWR) is on, remove the old lithium batteries. The red light for
the lithium battery will turn on.
Step 2: Press and hold the button near the battery holder for five seconds. After five seconds, all 3 lights on the board will flash on and off simultaneously for a few seconds. This
means that the controller memory has been reset and is ready to accept a new battery. The
controller will not allow itself to wipe its memory while lithium batteries are installed. At
least one of the batteries must be removed before wiping the memory. This is to help prevent accidental memory wipes.
Step 3: Place the new lithium batteries in the holders.
Replacement battery type: 2 x 3V CR123A lithium battery [Panasonic (CR123A), Sanyo
(CR123A), Duracell (DL123A), Energizer (EL123A)]
This is a common battery for cameras and other consumer electronics, and should be available wherever batteries are sold.
