Hi All,
We've got a couple of 330A Schindlers that we grudgingly work on. The owner did not want schindler back, and we'd go and occasionally fix minor problems.
The building is an old age home, and the old ladies there were hit by the doors a few times.
We suggested the PanaChrome detectors with closing lights and voice warnings (might help).
Anyway a couple of our guys went over to install them, and must have touched a wire wrong. The doors would not open, and closed automatically, even without the open/close wires from the carIO bd to the Lust door drive. We wound up showing error 94. We replaced the car board, and the error went away, but the door continued to close no matter what. Today we replaced the Lust drive, and had a running car.
I asked the guys there to put the old car boad back in, just to make sure that it was actually bad. When they did this, they wound up showing a communication error, so they put the new board back in, and now we still have the same error.
The error log shows an Init error, regarding LON, and inside the error log it shows an 20000006. In the controller, there is no EBLON board, only an EBCom.
I can do a LON Test for service pin, and see the car board. The guys swear that they didn't touch anything in the controller, and I believe them.
After this long winded story, I guess I need to know what devices are typically on the LON in a 330A? It appears that something isn't talking, but I'm unsure what it could be.
