Home Forums Active Threads This Week

Anyone have a lead on a cuttler hammer 72-2 could for a call contractor? 220VAC 38 OHMS resistance. Can't replace with a new standard resistance contractor as the floor and directional contractor coils are in series. Don't want to redesign the circuit if I don't have to.

I need help finding an inclinator programming tool that has a cat five cable connection please.
Respectfully,
MV

Just took on a duplex 330a, single riser. Top floor quit taking calls, bad board. changed board out, worked for a week, then have up. Board tested good on another floor. Car will not go up if lower floor switched to mimic top floor. Redid the 2 cat ends, no change. Cable test ok with lan tester. Controllers lon tests ok. Am I missing something? Did work briefly while had hall station off for testing, then nothing. Thoughts? Ideas?

Hello all.
I picked a BC108 as a means to get some family members into my house for the coming holidays. I ran it up and down a couple of times previously, but yesterday I noticed it was not going up. The large threaded rod is turning but the platform won't raise. It goes down without issue. I look at the back and I see this slotted bearing moving freely on the turning shaft (screenshot). Am I correct that the bearing needs to be pushed down the shaft a bit so it's groove is situated where the weld beed is located? Any help is appreciated.
--Rick