Hello everyone, I have to change the board of car botton for a Bionic 5 from Schindler.
But I can see the CF15 parameter (from menu 40) for the configuration, neither with cadi GC 3.10.
Do you know how can I find it?

It could be that the COP has not been recognized correctly.
→ Rel.2 (with SW V9.21): A learning travel has to be
made to recognize the COP. (Keep in mind that the
learning travel may erase some configurations. See
chapter 4.10.2)
→ Rel.4 (with SW ≥ V9.34): Perform a COP detection
with help of HMI menu 10, submenu 129 ([129 0] to
[129 1] and OK)

thank you for the advice !
i'll go with the procedure for rel.4

do you have any manual for cadi cg v3.10 ?
i'm trying to learn how to use this software.

With the recognition procedure (129) the new board works !

where do you get a Key for cadi