Hello everyone,
I am working on a 330A, and was getting it ready for the annual inspection. The bell and phone were not able to be called from inside the car, so we wanted to see what was going on with the push buttons for the I/O board. We checked the I/O board and the push buttons for both the phone and the bell were broken off.
The elevator was working totally fine, so we were only going to replace those push buttons on that board. Once we put everything back together, the controller started saying block ready, and the fire hat inside the car was on.
Tried to reset phase 1 and phase 2, no help. We reset the controller and now all of the floor call buttons (1-4) are stuck on. And the controller still say Block Ready.
Log says 1207 init something, when I go into extra info it’s 2000006 which I believe is EBLON missing.
We took the 360 out, bled the cap and still nothing. We then bled cap on the main controller, still nothing.
Kept the elevator off for two days, bled the 360 cap again, still nothing.
Any tips as to what to do next?
