Home Forums General Discussion Technical Questions Cycling calls on Otis gen2 mrl

Hi, I’m looking to find the blue tool button combination to put a gen 2 mrl into cycle mode from top to bottom, specific floors, or random floors

Thanks

M1315 Rand-c
0 = disabled
1-255 = seconds between random calls

Rand h for hall calls

TPos-1 and TPos-2 would be used for specific positions. Also IO 323 and 726 to remove it from the group and disable the doors.

Guys:
I tried m1315 but it brings me up to a parameter adjustment page. Actually I do m 1 3 and then the third digit I put in begins changing a parameter. I see nothing about Rand c. On this controller though when I’m in the blue tool all I have is menu 1 ocss and 2 Mcss after the module key. Any ideas where it would be?

I tried m1315 but it brings me up to a parameter adjustment page. Actually I do m 1 3 and then the third digit I put in begins changing a parameter. I see nothing about Rand c. On this controller though when I’m in the blue tool all I have is menu 1 ocss and 2 Mcss after the module key. Any ideas where it would be?

Sounds like you have old software. Try plugging into the installation port with the umbilical plugged into the GECB board.